You will need this account information email and password for the authentication when you launch a Dirac product for the first time. This will add the correct product license to your account. On this page, you are requested to provide your email address and a password to create an account and register your activation key. This page lets you register a Dirac software license using the activation key from Dirac. None of the combinations I've tried so far sounds bad, but I have some experimenting to do with the curtains in Dirac, to maybe limit the corrections to my room's transition freq, or 1kH, or some other value.Welcome to the Dirac Activation page. I'm going to have to finagle the user trims In the HTP-1 to match the Dirac trims, and try it that way. Dirac trimmed down my LCR and Subs about -15dB, to match my surrounds and tops, so the levels are not even close. The problem is, though, that I can't just enable/disable Dirac for a nice A/B comparison.
I'm currently running through some listening tests, comparing Dirac, PEQ, and clean, in the various combinations. Wouldn't it be nice if REQ software checked its own results, and made further refinements with multiple iterations? Fortunately the HTP-1 has 16 bands of PEQ for each of the 16 channels. They bear little resemblance to what I measure with REW after the Dirac cal. They did respond quickly to my first email, though.Īnd to echo what Kal Rubinson said, the "Corrected" graphs in Dirac are merely Predicted. It's only been a day since I sent the data, but I haven't heard back yet. I've reached out to Dirac Support, and they requested my REW. One time it reversed the polarity of the Center channel and the Subs. I've run Dirac about five different times so far, and I don't always get the same results.
I swapped the sub polarities, and it solved the problem. I ran REW on the system after Dirac, and, sure enough, there was the huge notch in each speaker/sub FR at the crossover freq. The problem is, I think, that my Zaph Audio SB12.3 mains and ZD3C center have their tweeters and mids polarity reversed, due to a 2nd order crossover on the woofers. The subs run off of one output channel on the HTP-1 via a Y-splitter to two channels on the Monolith 7X amp. They're installed one above the other in the wall, so the distance to the MLP is the same. I'm having an issue with Dirac 2.4 on my Monoprice HTP-1 inverting the phase of my two FI IB318 Infinite Baffle subs.
0 kommentar(er)
